您要访问的页面不存在

您可在下面搜索框中输入您想搜索的内容

About searching
关键词
类型
仅在内容类型
Languages
Languages
  1. High-performance 3 axis MEMS sensor that can be installed with ADcmXL3021 standard mechanical screws

    … bandwidth is as wide as DC to 10 kHz with a flatness of 5%, enabling us to track the main vibration characteristics … noise density  25 μg/√Hz Broadband : DC to 10 kHz (5% flatness) Embedded high-speed data sampling 220 ksps … High-pass filter cutoff frequencies : 1 kHz, 5 kHz, 10 kHz Low-pass filter cutoff frequencies : 1 …

  2. 处理稳压器高开关频率的 PCB 布局 (二)

    … 受电感影响的输出波形 通过下图 (图5) … 图5 放大输出波形 总结 …

  3. 如何使用Altera Interface Planner高效设计FPGA引脚布局

    … Tools 菜单,启动 Interface Planner。单击下图 (图5) 所示 Flow 窗格中的 Initialize Interface Planner … 图5 Initialize Interface Planner …

  4. 处理稳压器高开关频率的PCB布局 (三)

    … BUCK 转换器的功率级如下图 (图5) 所示,降压转换器看起来与 BOOST … 转换器的 PCB 布局完全相同。 图5 降压转换器配置图 …

  5. High-performance 3 axis MEMS sensor that can be installed with ADcmXL3021 standard mechanical screws

    … bandwidth is as wide as DC to 10 kHz with a flatness of 5%, enabling us to track the main vibration characteristics … noise density  25 μg/√Hz Broadband : DC to 10 kHz (5% flatness) Embedded high-speed data sampling 220 ksps … High-pass filter cutoff frequencies : 1 kHz, 5 kHz, 10 kHz Low-pass filter cutoff frequencies : 1 …

  6. 巧用数字电位计调节 APD 偏置电压

    … 为例,数字调节 CTRL 电压电路,如下图 (图5) 所示:  图5 AD5142 数字调节 CTRL 电压电路 … 和 100 kΩ 电阻可选 独立逻辑电源 (1.8V 至 5.5V) 宽工作温度范围:–40°C 至 +125°C …

  7. ADI 多协议工业以太网交换机

    ADI 多协议工业以太网交换机 2022年01月25日 作者 Boris Wang 文章来源 Cytech Engineer …

  8. 谈峰值电流控制模式下的次谐波振荡

    … 图5 ADP2386内部框图,红框内为斜坡补偿部分 …

  9. ADI在储能系统的 BMS 及电源系统设计 线上直播

    … 4. 大功率储能高压母线的电压电流监测 5. 功能安全设计理念及系统级的安全考虑 … 直播礼品 一、全程参与奖 5个: 膳魔师保温杯(观看全程直播) 二、早到奖 5个:小爱音箱 …

  10. How to reduce input switching noise in the power design of a FPGA board?

    … RMS current for a single output is as shown in Figure. 5. Dual input currents IIN 1 and IIN 2 add up to a large … impact of system problems caused by noise. Figure 5 : Normalized Input RMS Current for Two-Phase Operation From the normalized input RMS current graph shown in Fig. 5, estimate the RMS current during the two-phase operation. …